Halite – A new calibration material for microdrilling resistance measurements

This paper aims at proposing a new calibration material for microdrilling resistance measurements. Microdrilling resistance is a microdestructive method mainly used in built heritage in order to determine the strength profile in depth. This method is suitable to detect changes in the material cohesion, either due to a different state of preservation or to the action of a consolidant. Calibration materials are often used in microdrilling measurements in order to characterise the drill bit initial value and to correct the variations existing within the initial values of a set of drill bits. Calibration materials are also useful to detect the wear effect on a drill bit due to an abrasive stone. Moreover, such materials can be used for comparing results obtained with different microdrilling machines. In this work, halite was chosen to be tested as a calibration material due to its properties, as low hardness and isotropy. Halite single crystals and halite salt stone from different provenances were tested in order to evaluate the suitability of this material to the requests of a calibration material for microdrilling resistance applications, as for instance being homogeneous, non-abrasive, sensitive and available worldwide. Experimental results show that halite from different provenances is very homogeneous, especially in the crystalline form. This form of halite is slightly more expensive than stone halite; however its costs are comparable to ARS and significantly lower than Macor (other calibration materials commonly used for microdrilling resistance measurements). Due to the advantages of halite for calibration purposes, this material should be further tested by other authors in order to validate our conclusions.