Cycling on rollers: influence of tyre pressure and cross section on power requirements

The resistance against a cyclist while riding on rollers is due mainly to rolling resistance produced by the deformation of the tyre as it rolls against small diameter drums. Resistance is then combined with wheel speed to set power output. The effect of tyre pressure and cross-section on power was investigated by systematically altering the pressure (552 kPa, 690 kPa, and 827 KPa) in a 20c, 23c, 25c, and 28c tyre of the same design while riding at a wheel speed of 45 kph. Average power over 1 minute was measured with a Power Tap Hub (Tune Corporation, Cambridge, Massachusetts, USA) on five occasions. Statistical significance was evaluated at p < 0.05. Power requirements increased significantly with each reduction in tyre pressure for all tyres and pressures except the 25c between 690 and 827 kPa. The 20c tyre required significantly more power from the cyclist at each tested tyre pressure when compared to the other tyres (which were not different from each other). The differences in resistance from tyre size were not observed when ridden on the road. Additionally, a slightly different tyre design from the same manufacturer responded similarly in the 20c, but was significantly different in the 23c size. It was also observed that power requirements increased significantly when both the wheels were ridden on the rollers as compared to just the rear wheel. These results indicate that the power requirements may be significantly altered by the cyclist by adjusting tyre pressure, tyre cross-section size, tyre type, and with the number of wheels contacting the rollers. However, the magnitude of these power requirements may not be suitable for intense workouts of trained cyclists.     

The stroke has only a minor influence on direction consistency in golf putting among elite players

In the golf instructional literature, the putting stroke is typically given higher priority than green reading and aiming. The main purpose of this study was to assess the importance of the putting stroke for direction consistency in golf putting. Kinematic stroke parameters were recorded from 71 elite golf players (mean handicap = 1.8, s = 4.2) on 1301 putts from about 4 m. Of the different factors deciding stroke direction consistency, face angle was found to be the most important (80%), followed by putter path (17%) and impact point (3%). This suggests that improvements in consistency of putter path and impact point will have very little effect on overall putting direction consistency and should not be prioritized in the training of elite players. In addition, mean stroke direction variability for an elite player (European Tour) was found to be 0.39 degrees, which is good enough to hole about 95% of all 4-m putts. In practice, however, top professionals in tournaments only hole about 17% of 4-m putts. We conclude that the putting stroke of elite golfers has a relatively minor influence on direction consistency.     

Science education: innovation in rural and remote Queensland schools

Outside its heavily-populated south-eastern corner, Queensland is a huge administrative area with many small, remote communities that can be separated by hundreds of kilometres of dirt road, or, in other areas, not accessible by road. In this study, parents, students and teachers in nine schools from rural and regional Queensland were interviewed about their perceptions of school science. Teachers, parents and students defined remoteness by reference to their social ties, as well as the social capital and resources they drew on to teach science meaning that not only did different groups differ in their interpretations of remoteness; different teachers in similar circumstances also responded differently. Science teachers’ responses to remoteness were related to their perceptions of school-community communication and their perceptions of their freedom to innovate. Teachers who felt that remoteness gave them more freedom and recognised opportunities to utilise their environment created innovative and relevant science programmes. Teachers who felt their remoteness gave them less freedom felt isolated from the community were less likely to innovate.