关于大容量电力电容器极间交流耐压试验的探讨

根据绝缘结构分析和实践经验证明尽快执行用交流板间耐压代替直流耐压的新标准的必要性、紧迫性和可行性.     

电力系统电压稳定性的研究

对国内外电压稳定问题研究的现状进行了概述。特别介绍了对电压失稳机理的认识以及当前广泛采用的几种电压稳定性的分析方法，而且还介绍了电压稳定研究进一步发展的方向。     

三相非线性负载时中线谐波电流和电压分析——兼论医院电气设计中的谐波治理与接地系统的关系

通过对三相非线性负载时正弦电流畸变波形的数学分析,论证中性线上存在剩余基波和谐波电流,以及中性点上谐波电压存在的原因,给出三相电源负载与中性点上电压的关系式,为三相非线性负载下接地系统的选择提供参考依据。     

三相异步电动机Y-△降压起动的PLC控制线路设计

针对三相交流异步电动机在额定电压下直接起动时存在的弊端,通过PLC中的定时器及互锁、连锁等保护手段对电动机Y-△降压起动加以控制,从而避免操作不当或误操作而引起事故。这里主要讨论改进后的继电器接触控制电气原理图,对应的I/O配置接线图,PLC梯形图,部分程序,并对改进后的原理进行分析,从而得出采用PLC控制的Y-△降压起动的优越性。     

Position detection and vibration monitoring system using quad-cell optical beam power distribution

In this paper, we study the accuracy of an optical vibration sensing system using Gaussian beam analysis. The proposed optical system uses a He-Ne laser source whose Gaussian beam impinges on a quad-cell photodetector array. The normalized optical power for each cell is obtained through numerical simulation based on the well-known Gaussian beam optics formulation, as the beam scans the plane of the photodetectors due to vibration. The system detection principle lies upon finding a relationship between the power distribution of the quad-cell and the position of the beam centroid, which allows us to identify the characteristics of the vibration applied, such as direction, frequency and strength. The aspects of practical implementation and experimental limitations on the power distribution accuracy are discussed and the discrepancies with the theoretical results are presented.     

电压互感器测量不确定度的评定

文章通过实例分别对电压互感器的比值差和相位差的测量不确定度进行了分析和评定。     

500KV变电站雷电过电压仿真研究

将500kV变电站和进线段结合起来,考虑远近区杆塔冲击接地电阻、雷击点与变电站的距离等影响因素,采用ATPDraw对500kV变电站的雷电侵入波过电压进行了仿真研究。研究表明,近区杆塔接地电阻、雷击点对雷电过电压的大小有较大的影响;当设备过电压较严重时,母线上增装一组避雷器能有效降低过电压;最后,提出在主变避雷器前串联...     

浅析气相色谱技术诊断变压器故障的应用

气相色谱技术能够对运行中的变压器进行实时监测,尽早发现变压器内部故障,因为变压器内部故障时变压器和发热气,中大部气中,通中气的及,变压器故障故障的及部。     

基于LonWorks技术的娄宇自动化系统在变电站的应斥

文章讲述了楼宇自动化（BAS）的基本构成,并介绍了LonWorks技术在楼宇自动化中的应用,着重介绍了基于LonWorks技术的楼宇自动化系统的设计方法。最后详细给出了楼宇自动化系统中供配电系统、照明系统及电梯系统监控的主要内容。     

Digitally controlled boost PFC converters operating with large scale load fluctuations

When boost power factor correction （PFC） circuit works with large scale load fluctuations, it is easy to cause a higher total harmonic distortion and a lower power factor because of traditional controllers and inductor cur- rent mode. To solve this problem, this paper proposes a PFC control system, which can operate with load fluctuations up to 1 000 W by using duty cycle feed-forward control theory to achieve smooth switching mode. The duty cycles in the next period of the control system are pre-estimated in the current cycle, which enhances the speeds of AD samplers and switching frequency, and reduces the cost and volume of the equipment to some extent. Introductions of system decoupling and feed-forward of input-voltage greatly improve the system performance. Both theoretical simulation and experimental results prove the advantage of the proposed scheme.