| 基于ANSYS的多管材挤出定型模冷却系统的设计 |
| |
| 引用本文： | 周雪峰,冯金彪,李杰,王延民.基于ANSYS的多管材挤出定型模冷却系统的设计[J].常熟理工学院学报,2008,22(10):46-48. |
| |
| 作者姓名： | 周雪峰 冯金彪 李杰 王延民 |
| |
| 作者单位： | 1. 常熟理工学院,化学与材料工程系,江苏,常熟,215500
2. 西南石油大学,油气藏地质及开发工程国家重点实验室,四川,成都,610500 |
| |
| 摘 要： | 基于ANSYS软件，对塑料异型材在定型模内的温度场进行数值模拟．通过分析型材冷却过程中的热传递方式，对计算模型、初始条件和边界条件进行了更符合生产实际的假设或赋值，并根据模拟结果进行冷却水道的布置．
|
| 关 键 词： | ANSYS 定型模具 多管挤出 |
The Design of Cooling System of Multi-extrusion Die Based on ANSYS |
| |
| ZHOU Xue-feng,FENG Jin-biao,LI Jie,WANG Yan-min.The Design of Cooling System of Multi-extrusion Die Based on ANSYS[J].Journal of Changshu Institute of Technology,2008,22(10):46-48. |
| |
| Authors: | ZHOU Xue-feng FENG Jin-biao LI Jie WANG Yan-min |
| |
| Institution: | ZHOU Xue-feng1,FENG Jin-biao1,LI Jie1,WANG Yan-min2 (1.Department of Chemistry , Material Engineering,Changshu Institute of Technology,Changshu 215500,China,2 .Sfate key Laboratory of Oil , Gas Reservoir Geolgy , Exploitation,Southwest Petroleum University,Chengdu 610500,China) |
| |
| Abstract: | The numerical simulation of temperature field of the plastic profile based on ANSYS is applied.Plastic profile produced by extrusion die is cooled down and calibrated by calibrating tool.Based on the analysis of heat transfer during the cooling process,the calculation models are presented,hypo theses and evaluations about initial and boundary conditions are given.Those are nearer practical manufacturing,and then ANSYS is applied to simulate the cooling process of plastic profile staying at calibrating tool.... |
| |
| Keywords: | ANSY |
| 本文献已被 CNKI 维普 万方数据 等数据库收录！ |
|
